Sunday, May 6, 2012

Po'chop.......

.......as in motorplate. Pretty straightforward - a posterboard template, a 1/4" thick piece of 6061, a jigsaw, a little time on the belt sander, and a few holes. Came out nice. You could do the same thing in 1/4" steel plate if you wanted, or you could buy one for $150.00 . For Elliot's bike.

4 comments:

Glennon said...

Looking good Rich, see you in a day or two bud.

J-Rod said...

Nice piece...bolted over the Primo alt cover?

Clean work as usual.

Irish Rich said...

Yeah, putting it over the alternator cover lines it up on the same plane with the bearing support - no spacing. You do have to take some of the rib off of the bearing support to get it to sit flush. But, it lines everything right up.

J-Rod said...

Very clean, old man. I expect nothing less.